#Woodworking spline jig for free
#Woodworking spline jig free

I would be worried about using clamps to hold it as it could easily take your joint out of square.ДЇor my OCD friends, a drinking straw can cleanup and interior glue squeeze out. This allows you to just use hand pressure to вЂњclampвЂќ the last piece in place. The CA glue sets super fast and the wood glue is a long term adhesive onceВ cured. I used wood glue in conjunction with CA glue. It is also worth noting, when gluing and screwing the pieces together, to avoid the slots you made earlier. If not, you can use a small square or even a couple blocks of wood to clamp the joint square. Of course make sure you particular saw has a perfectly square edge. I nice trick is to use the edge of your table saw as a 90В° clamping jig. Take your time with this as it helps to get this right now. Make sure the two legs of the triangle meet at 90В°. If there was one thing about this jig I would say is important this would be it. This is to allow 1/4вЂі вЂ“ 20 carriage bolt heads to pass through. Make sure to also drill the larger holes in the end of the slots according to the drawings. If you do end up with some uneven spots or just want to clean up some burrs, try using some sandpaper double side taped to a piece of scrap wood. You can use a jigsaw as shown above.Д«ut being the 1/4вЂі вЂ“ 20 hardware has a 1/4вЂі square shoulder on it, I prefer a bit more accuracy.ДЄ trim router with a 1/4вЂі spiral bit installed does a much cleaner job when making the slots. Layout and drill the 1/4вЂі holes according to the drawings. The longest portion of the triangle is intentionally left long at this point. One piece has only one bevel on one end and the other piece has a 45В° bevel on each end. Set your table saw blade to 45В° and cut the two remaining pieces.

#Woodworking spline jig free

Again, you can find the free measured drawing here. Start by squaring up one end of your workpiece.Д¬ut the first piece to length. All parts can be cut from one piece of wood 32вЂі long. I started by cutting my pieces to 7 1/2вЂі wide.

#Woodworking spline jig for free

I made a set of measured drawings that are available for free if you are wanting to make this jig. One side is for cutting grooves into miters to accept splines, the other side is a simple but effective tenoning jig that works surprisingly well for such a simple jig. TheВ first of hopefully many more add-onвЂ™sВ is my mitered spline and tenoning jig. I wanted to get the most out of it and use it as the foundation for other shop jigs. When I originally designed my sled, I had add-onвЂ™s and accessories in mind. This jig is rather easy to make, itвЂ™s inexpensive, and in addition to being a вЂњdouble-dutyвЂќ jig, it also utilizes the existing platform of my table saw sled. And I know first hand how expensive they can be, considering I have purchased some in the past. Another reason was to be able to do these joints without buying expensive factory made jigs. Being able to make accurate tenons as well as structural splines for mitered joints was the reason behind this build.